Intelligent cartoning machine (with snap bottom)

Category

Intelligent Box Packing Machine Series

Keywords

Consultation

Products Describe

Equipment scheme description：

Manually placed products--Detection photoelectric detect the product--Automatic box forming--Automatic forming of buckle bottom--Left page automatic folding molding--Push the material into the box automatically--Right page automatic folding molding--Large folding automatic folding forming--output--finish

Main equipment technical parameters

2.1 Parameter data：

NO.	Type	RY-Pro80-Z4	Remark
1	Speed	30-40 box/min	Depends on the product
2	Carton size	L70-165×W35-80×H35-80mm
3	Motor power	1.5KW
4	Power supply	220V 50/60Hz
5	Paper	gray cardboard, white cardboard, corrugated paper
6	Air source	0.6-0.8 Mpa
7	Overall dimension	about 340014001800mm
8	Weight	about 1200kg

（Rongyu reserves the power of final interpretation）

2.2 Configuration information：

No.	Name	Brand	Remark
1	PLC	DELTA
2	Touch screen	DELTA
3	Frequency converter	DELTA
4	Detector	OMRON
5	Switching power supply	MEAN WELL
6	Breaker	SCHNEIDER
7	Button	SCHNEIDER
8	Contactor	SCHNEIDER
9	Relay	OMRON
10	Pneumatic element	AirTAC/SMC/Made in China
11	linear slide guide rail	SHAC
12	Motor	DPG

Requirements for the cartoning and packaging process

Carton Requirements
NO.	Content	Remark
1	L\W\H refer to picture	Figure 1
2	Pre-folding more than 120 degrees before the carton adhesion, and after bonding shall not be adhesive again; Indentation to the deepest
3	Corrugated box grain for vertical grain; Gray card, white card box grain for horizontal grain
4	The left and right side pages need to reserve paper thickness gap after forming	Figure 2
5	The chamfering radius at both ends of the width need to add 2mm, and no straight edge is left after chamfering	Figure 3
6	The large folding leaf of the carton shall be on the same side as the concave side sheet and the folding direction shall be on the right side of the carton; The edge of the bottom fold should be retained at 7 degrees of beveling; There should be a gap of 1-2mm between the convex and concave sides of the bottom fold.	Figure 4
as shown
Figure 1	Figure 2	Figure 3
Figure Figure 4
Summary: The above are the carton automation process requirements; According to the above process requirements and provide qualified samples to our technical confirmation; The final process is subject to the acceptance of the equipment (where the packing material is stored, the paper should be neat and undeformed, not be damp).